Easy Install – Options
What Is The Easiest System To Install?
AtSite is by far the easiest system to install. You do not need a PC on site, just iPods / iPhones / iPads for installation. You will need WiFi if you use an iPod or iPad.
Note – you cannot use an Android phone to do an install, it does not have the management functions. You can later use Android for logging though.
Classic Wand Systems can also be made easier to install with some help from Elite-ID.
AtSite Easy Install
There are some options with AtSite that make it easy.
AtSite Self Install
Clients with many sites and available support staff usually do the following;
- Order the beacons required,
- Affix them to selected locations,
- Use an iPhone to setup each Beacon into WebEye.
Done. Note, you may need to install WiFi and setup your loggers in addition to the above.
AtSite Elite-ID Assisted Install
New clients like this option, as well as clients with limited support staff and just want an easy install.
- Order the beacons required,
- Option-1, submit a list of location names. Elite-ID will setup your beacons then individually package and label them,
- Option-2, Elite-ID setup the site with location names of “Locaiton-1” and “Location-2” etc. When you install the Beacons, write down where each is, email Elite-ID, the names will be changed and the setup is finished. This is the most popular option,
- Affix Beacons to selected locations.
Done. Note, you may need to install WiFi and setup your loggers in addition to the above.
Classic Wand System Easy Install
There are 2 options – one way if you know the locations names, and another if you do not know the location names.
Known names – Elite-ID Assisted Install
If you know where your devices are going to be installed, this is the best option;
- Order the iButtons or RFID points required,
- Submit a list of location names,
- Each iButton / RFID point will be setup with the name you require. Each will be individually packaged and labeled.
- You install the device at the location required. Your database configuration is complete!
- Install software in a PC, charge and use your Wands.
Unknown names – Elite-ID Assisted Install
If you do not have a list of location names then use the following option;
- Order the iButtons or RFID points required,
- Request Elite-ID put each iButton into an individual bag with the serial number on the bag,
- You install the device at the location required. Write the location (and site) name on each bag,
- Log each iButton with a Wand as you install it,
- email or fax the serial number and location names to Elite-ID,
- Elite-ID will setup the serials for you,
- Install software in a PC, charge and use your Wands, upload data to WebEye as soon as possible.