Search Knowledge Base by Keyword
XL-Unloader Lockup
XL-Unloader Lockup
XL-Unloader Lockup happens if it’s power is glitched or it is switched on and off quickly. This will not cause loss of data or damage the device.
Symptoms are any of the following – red or green or both leds permanently on, beeper beeping permanently.
To fix;
- Remove BOTH cables from the rear of the XL-Unloader.
- Put the switch in the DOWN position (assuming the label is facing up).
- Leds should now be off, and any beeping stopped.
- Wait 30 seconds.
- Connect ONLY the power cable. You should now have the red flashing “ready” light.
- Connect the data cable.
You have fixed it!